Skip to content
CostlyHome

Georgia · 0.85× national labor · 6" frost depth

Fence cost calculator for Georgia

Itemized fence estimates using Georgia labor rates, local frost depth and state permitting guidance. Enter your dimensions and see the full breakdown instantly, no email required.

  • No email required
  • No phone number
  • No contractor calls
Fence
ft

Measure the perimeter you intend to enclose

15-20 years lifespan · stain or seal every 2-3 years

Gates & layout

About $175 each installed

About $450 each installed

Each needs a braced post assembly

Slope adds labor for stepping panels

Location & install

Labor multiplier applied: 0.85×

Who is installing?

Tear-out and haul-away, about $4 per linear foot

Total estimated cost

$3,930to$5,310

Midpoint $4,621 · range reflects local pricing and site conditions

Per linear foot
$30.81
Posts needed
20
Concrete bags
40
Cost per year
$264
Lifespan
15-20 years
Labor rate
0.85×
Itemized cost breakdown
ItemCost
Panels, pickets & rails150 ft of wood at 6 ft height$1,800
Posts & concrete20 posts at 8 ft spacing, 40 bags of concrete$260
Corner post assemblies4 braced corners$180
Gates & hardware1 walk$175
Waste allowance10% overage on material for cuts and damage$180
Installation laborGeorgia rate (0.85x national) on flat ground$1,919
PermitTypical municipal fence permit, verify locally$107
Estimated total$4,621

Same fence, other materials

  • $3,269
  • $4,621
  • $5,557
  • $6,638
  • $7,389
  • $8,231

Example fence costs in Georgia

Pre-computed for common project sizes with the Georgia labor multiplier of 0.85× already applied.

200 ft wood privacy fence in Georgia

6 ft tall, one walk gate, four corners, flat ground

$5,100 to $6,900

$29.99 per linear foot

100 ft vinyl fence in Georgia

6 ft tall, one walk gate, no ongoing maintenance

$3,290 to $4,450

$38.67 per linear foot

300 ft chain-link fence in Georgia

4 ft tall, one walk gate, large perimeter

$4,410 to $5,960

$17.29 per linear foot

Fence material comparison for Georgia

Every material priced against the same 150-foot, 6-foot-tall fence with one walk gate and four corners, at Georgia labor rates.

MaterialTotalPer footLifespanCost / yearMaintenance
Chain-link$3,269$21.7920-25 years$145Almost none; check for rust at cut ends
Wood$4,621$30.8115-20 years$264Stain or seal every 2-3 years
Vinyl$5,557$37.0525-30 years$202Rinse annually; no sealing required
Aluminum$6,638$44.2530+ years$204None; powder coat does not need refinishing
Composite$7,389$49.2625-30 years$269Rinse annually; no sealing required
Wrought iron$8,231$54.8750+ years$150Sand and repaint rust spots every 3-5 years

The highlighted row is the material most commonly installed in Georgia. Cost per year divides the installed total by the midpoint of the material's expected lifespan.

How much does a fence cost in Georgia?

A standard 150-foot, 6-foot-tall wood privacy fence in Georgia runs $3,930 to $5,310 professionally installed, or about $30.81 per linear foot. The same fence in vinyl comes to $4,720 to $6,390. Chain-link, the cheapest way to enclose the same perimeter, lands at $2,780 to $3,760.

Georgia construction labor runs about 15% below the national average, which puts it in the bottom third of US labor markets by cost. That single multiplier moves the wood fence estimate down by roughly $349 compared with a national-average install of the identical fence. Labor is 45-55% of a professionally installed fence, so the multiplier matters more than any material decision you make.

Doing the work yourself removes the labor line entirely. On the 150-foot wood fence above, a DIY install in Georgia comes to roughly $2,877 for materials, concrete, a tool rental allowance and the permit. That is a real saving, but post setting is genuinely hard work, and a fence that is out of plumb is expensive to correct.

Georgia soil, climate and frost depth

Georgia has a shallow 6-inch frost depth, which keeps post setting quick and cheap. Posts must be set below the frost line or seasonal freeze-thaw will lift them out of plumb. That is the most common reason a fence fails early, and it is entirely avoidable at install time.

Ground conditions here are the well-known Georgia red clay, sticky when wet, brick-hard when dry. Combined with a climate that is humid subtropical with long hot summers and short mild winters, the practical effect is straightforward: Red clay holds water against posts, so a gravel base beneath each post materially extends service life.

The material most commonly installed across Georgia is wood privacy, which reflects both the local climate and what contractors here stock and know how to install well. Choosing outside the local norm is entirely reasonable, but expect a smaller pool of experienced installers and a slightly higher quote.

Fence permits in Georgia

Atlanta requires permits for fences over 6 feet in rear yards and 4 feet in front; decks over 30 inches require a permit and inspection statewide.

Our estimate includes $106 as a permit allowance, scaled to Georgia fee levels. Actual fees vary widely between municipalities, and some rural counties charge nothing at all. Before you buy material, call your local building department and confirm three things: the height limit for your yard, the required setback from the property line, and whether a survey is required.

If your property is in an HOA, that review is usually the stricter gate. HOA design rules routinely restrict material, color and height beyond what the municipality requires, and approval can take several weeks.

Which fence material lasts longest in Georgia?

Upfront price and lifetime cost rank differently. Spread across expected service life, the 150-foot fence above costs $264 per year in wood, $202 per year in vinyl, and $145 per year in chain-link. Vinyl costs noticeably more on day one and less over twenty years, and that comparison does not even count the stain and sealer a wood fence needs every two to three years.

For Georgia conditions specifically: Red clay holds water against posts, so a gravel base beneath each post materially extends service life. Weigh that against how long you plan to stay. If you are moving inside five years, upfront cost is the number that matters. If this is a long-term house, lifetime cost is the honest comparison.

Privacy, picket and board on board fence costs in Georgia

Style changes the lumber bill without changing the posts, and it is where a lot of Georgia quotes diverge from each other. A solid 6-foot privacy fence, the default in the privacy fence calculator above, costs $4,621 across 150 feet here. A 4-foot picket fence in the same wood costs about $3,382, because spaced pickets leave roughly a third of the panel face open and the shorter posts need less concrete.

Board on board sits at the other end. Overlapping every board so no gap opens as the lumber dries takes about 35% more material than a flat side-by-side panel, which brings the same 150-foot Georgia fence to roughly $5,314. That is about $693 more than the standard privacy build. Whether that premium is worth paying here comes down to the local climate. Red clay holds water against posts, so a gravel base beneath each post materially extends service life.

To price any of these, set the calculator to wood at your height and length. It returns the solid-panel figure, and the two adjustments above bracket the picket and board on board versions of the same run.

How we calculated these estimates

Every figure on this page comes from the same open formula the calculator above uses. We start from a 2026 national baseline for materials and installed labor, apply the state labor multiplier published by the Bureau of Labor Statistics for construction trades, then add the line items your inputs call for: gates, corners, removal, permits and a waste allowance. Nothing is hidden behind a lead form, and no contractor pays us to appear here. The result is a planning range, not a quote. The low figure assumes straightforward access and an efficient crew, and the high figure assumes obstacles, difficult access, or premium material grades.

Fence cost FAQs for Georgia

How much does 300 feet of fencing cost in Georgia?

In Georgia, 300 feet of fencing costs between $5,150 and $18,380 installed, depending on material. Chain-link is the cheapest at about $6,064, a 6-foot wood privacy fence comes to about $8,767, and vinyl about $10,639. Those totals include posts, concrete, one walk gate, four braced corners, a 10% waste allowance and a permit, priced at the Georgia labor rate of 0.85 times the national average.

How much would a 200 ft privacy fence cost in Georgia?

A 200-foot, 6-foot-tall wood privacy fence in Georgia costs $5,100 to $6,900 professionally installed, about $29.99 per linear foot. The same 200 feet in vinyl runs $6,160 to $8,330, and in composite $8,240 to $11,140. Labor is 45-55% of that total, which is why the Georgia multiplier of 0.85× moves the figure more than most material decisions do.

How much is a 20x20 fence in Georgia?

A 20x20 enclosure has an 80-foot perimeter, not 400 feet. You are fencing the boundary, not the area. At 80 feet in Georgia, a 6-foot wood privacy fence costs $2,280 to $3,090 and vinyl costs $2,710 to $3,660, both including four corners, a walk gate and a permit. Chain-link brings the same enclosure down to $1,670 to $2,260. Short runs cost more per foot than long ones because the gate, corners and permit spread across fewer feet.

What is the cheapest fence to install in Georgia?

Chain-link is the cheapest way to enclose a perimeter in Georgia at $21.79 per linear foot installed, largely because its 10-foot post spacing means fewer holes and less concrete than the 8-foot spacing other materials use. For an actual privacy fence, pressure-treated wood is cheapest at $30.81 per foot, or $4,621 for a 150-foot run. Measured over service life rather than upfront the ranking changes: wood costs $264 per year against vinyl's $202.

Is a 4 foot fence cheaper than a 6-foot fence in Georgia?

Yes, about 14% cheaper for the same material and length. A 150-foot wood fence in Georgia falls from $4,621 at 6 feet to $3,971 at 4 feet. The saving comes from shorter posts, shallower holes and 1.5 bags of concrete per post instead of 2, less material per panel, and slightly less labor. A 4-foot fence is also less likely to need a permit, since most height limits bite at 6 feet.

How much concrete do I need for fence posts in Georgia?

A 6-foot fence in Georgia needs about 2 bags of 80 lb concrete per post, and a 150-foot wood fence needs 20 posts, 40 bags, or roughly $260 of material. Georgia's frost depth is only 6 inches, shallower than the 30-inch hole a 6-foot post needs for stability anyway, so the standard hole already clears the frost line and the bag count above holds. Our concrete calculator sizes post holes at any diameter and depth and converts the volume into 40, 60 and 80 lb bag counts.

Do I need a permit for a fence in Georgia?

Atlanta requires permits for fences over 6 feet in rear yards and 4 feet in front; decks over 30 inches require a permit and inspection statewide. Our estimates include roughly $106 as a permit allowance for Georgia. Always confirm the height limit, property-line setback and survey requirement with your local building department before buying material, and check your HOA rules separately since those are frequently stricter than the municipal code.

How deep do fence posts need to be in Georgia?

Georgia has a typical frost depth of 6 inches, and posts should be set below that line so seasonal freeze-thaw cannot lift them. A common rule is one third of the post's above-ground height or below the frost line, whichever is deeper. Confirm the exact requirement with your local building department, since it varies by county.

Is it cheaper to build a fence yourself in Georgia?

Yes, substantially. A DIY 150-foot wood fence in Georgia costs about $2,877 against $4,621 for a professional install, a saving of roughly $1,744. The trade-off is real work: 20 post holes dug to 6 inches, plus mixing and setting 40 bags of concrete. Most homeowners need two full weekends and a second person.

What type of fence lasts longest in Georgia?

Ground conditions in Georgia are the well-known Georgia red clay, sticky when wet, brick-hard when dry, in a climate that is humid subtropical with long hot summers and short mild winters. In practice, Red clay holds water against posts, so a gravel base beneath each post materially extends service life. Wrought iron and aluminum last longest, 30 to 50 plus years, while vinyl and composite reach 25 to 30 years with almost no maintenance. Wood lasts 15 to 20 years and only if it is sealed every two to three years. Across the materials priced here, chain-link is the lowest total cost in Georgia at $3,269 for 150 feet.

Fence cost in other states

The figure beside each state is its construction labor multiplier relative to the national average of 1.00×.

Our estimates are backed by real data

Every figure on this page traces back to a published source. Where a government dataset is available, we fetch it at build time rather than typing in a number and hoping it stays true.

Labor rates
US Bureau of Labor Statistics, Current Employment Statistics, construction average hourly earnings by state, July 2026. National average $41.46/hr. Source
Material cost trends
Federal Reserve Economic Data (FRED), Producer Price Index, plastic construction products, iron & steel, fabricated structural metal, lumber & wood products, July 2026. Source
Frost depths
State and county building-code minimum footing depths, compiled per state. Confirm locally before excavating. Source

Data last updated: August 17, 2026

Related calculators